矩阵方程A^TXB=C的正定和半正定解

给出了矩阵方程Ａ＾ＴＸＢ＝Ｃ在正定和半正定矩阵类中有解的充要条件及解的一般表达式。     

Studies on basicity of alkali metal catron exchanged β and X zeolites by pyrrole-IR spectroscopy

The strength of basic sites has been measured by pyrrole-IR on alkali metal cation exchanged β and X zeolites, as well as NaOH loaded Naβ. The influence of cation type and the structure of zeolites on their basicity has been studied. The acidic and basic properties of the samples were investigated by NH3-TPD and isopropanol reaction. It was shown that the strength of basic sites on samples could be characterized by the shift of vNH band in the pyrrole-IR spectra. The framework oxygen charges were calculated from the Sanderson electronegativity. The changes in basic properties with various alkali metal cation are consistent with the changes of local oxygen charges of the zeolite framework.     

Pseudo-epitaxial C60 films prepared by a hot-wall method

We have used both reflection-geometry and grazing-incidence-geometry X-ray scattering to study thin films of C₆₀ evaporated onto mica substrates via a hot-wall technique. The growth mode yields close-packed C₆₀ planes, which are parallel to the substrate surface and which exhibit out-of-plane correlation lengths of 850 Å. In the film plane the C₆₀ is at best pseudo-epitaxial, with a 0.9° distribution of crystallite orientations, a 450 Å in-plane correlation length, and a 3.7% lattice mismatch, better than obtained by other thin film techniques but far from the accepted definition of single crystal thin film epitaxy.     

双层桥梁耦合系统的强迫振动

本文研究作为双层桥模型的梁方程耦合系统，利用Ｌｅｒａｙ－Ｓｃｈａｕｄｅｒ不动点定理，得到了一个关于这种系统的解的存在性定理，它类似于ＭｃＫｅｎｎａ和Ｗａｌｔｅｒ文２中关于吊桥方程的一个定理。     

压力淬火过程中锗的相结构研究

 应用高压原位差热方法，直接测量了压力下锗的固化参数─—固化温度与过冷度。高压差热信号表明，当压力大于3 GPa时，锗在凝固过程中可能发生结构相变。X射线结构分析表明，在最终的样品中除GeⅠ相外，还形成GeⅢ相和GeⅣ相。     

Surface grating formation and erasing on a-Se films

Surface relief formation at holographic recording on amorphous selenium films was demonstrated and investigated. The presence of this optical phase modulation component is essential for ensuring significant, stable and erasable optical recording in a-Se films at 290–320 K temperatures, where conventional photodarkening was known as insignificant and unstable. Photocrystallization can only be observed in super-exposed a-Se films at the given experimental conditions of hologram recording. Erasing behavior of surface relief gratings under heat treatment was also investigated in order to reveal further details of the mechanism. Photoinduced structural transformations within the amorphous phase, connected to local ordering under the condition of light-induced fluidity, are proposed as an explanation for the relief formation and erasing. The observed reversible optical recording process may be useful for the various optoelectronic applications of photoconductive a-Se layers. Received: 12 June 2000 / Accepted: 6 June 2001 / Published online: 30 August 2001     

TCH-600氧、氮、氢分析仪在唐钢的应用

通过TCH-600氧、氮、氢分析仪在唐钢的实际应用,重点介绍了助熔剂、坩埚、样品熔解及空白和校正过程中应注意的问题,钢铁样品分析条件的选择.     

Optimization of the surface texture for silicon carbide sliding in water

Surface texturing has been recognized as an effective means to improve the tribological performances of sliding surfaces. Usually, generation additional hydrodynamic pressure to increase the load carrying capacity is regarded as the most significant effect of surface texture. In the case of silicon carbide sliding against identical material in water, the experimental results indicate that surface texture is also helpful to improve the running-in progress to smooth the contact surfaces, showing another reason to result in low friction. Based on the consideration of enhancing the generation of hydrodynamic pressure and improving running-in progress, a surface texture pattern, which was combined with large (circle, 350 μm in diameter) and small (rectangular, 40 μm in length) dimples, was designed to maximize the texture effect on the load carrying capacity of SiC surfaces sliding in water. The friction coefficient of such textured surface was evaluated and compared with that of untextured and those only with large or small dimples only. The friction reduction mechanisms of the patterns with different dimples in size are discussed.     

Dielectric and optical properties of polymer-liquid crystal composite

Dielectric properties of polymer-liquid crystal mixture, having constituent polymer, poly-butyl methacrylate (PBMA) and liquid crystal, cholesteryl nonanoate, are reported as a function of frequency and temperature. The measurement has been done in a temperature range of 300-375 K and frequency range of 100 Hz-10 MHz. The dielectric permittivity and dielectric loss shows significant changes with the addition of polymer molecules in liquid crystal. The significant feature of composite formation is that the pure liquid crystal and polymer do not show dielectric relaxation in the frequency range covered, while the composite shows relaxation peak at a particular frequency. The optical transmittance of pure liquid crystal and composite has also been measured and compared.